How To Fix The Sound In A Cuckoo Clock

Download Article

Setting a cuckoo clock is a fairly simple process, but you must handle the clock gently and in the correct manner to avert breaking information technology. Hang and start the clock before setting the time, and so make whatever necessary adjustments to the speed of the clock if the time it keeps seems too fast or too slow.

1
Keep the clock in a vertical position. Earlier setting the clock, you lot should hang it on the wall where you intend to continue it. The clock must be in an upright position before you tin can fix it.^[ane]
- The clock should be 6 to 6.5 feet (1.eight to ii thou) to a higher place the floor.
- Use wide woods spiral (like a #eight or #x) that is long enough the fasten into a stud in the wall. You must choose a spot in the wall with a stud; do not attempt to hang the clock where no stud rests.
- Place the screw in the wall at an upward 45 degree angle. It should stick out by about i.25 to 1.5 inches (3.2 to iii.8 cm).
- Hang the clock on this screw. The clock must be flush confronting the wall.
- If the bondage are notwithstanding in their packaging, slowly remove the packaging and loosen any knots. Pull out the security wire betwixt them. Do not handle the chains in this way while the clock is horizontal or upside down since doing so tin can cause the chains to come loose.
- One weight should exist placed on each chain hook.
- Make sure that the pendulum rests on the hanger at the bottom of the clock, near the back.
2
Unlatch the cuckoo door. If the cuckoo bird'south door is kept closed with a wire latch, y'all need to movement the latch aside.^[2]
- Failing to unlatch the door can foreclose it from opening when it should. This tin can cause harm to your clock.
- If the cuckoo does not call at the appropriate time even with the door unlatched, cheque the wire latch again to make sure that it did not slip dorsum into a locked position. You should besides make sure that the close-off switch is not flipped into a silent position (when applicable) and that all clips, rubber bands, and Styrofoam packing materials have been removed from inside the clock.
Advertisement
3
Wind the clock. Grab the chain that does non have a weight on it and gently pull it directly down toward the floor.^[three]
- Exercise not lift or otherwise touch the weighted chain as you wind the clock. There must always be some force per unit area on the weighted chain in order to keep it in place within the clock.
- The unweighted concatenation may have a ring on it.
4
Nudge the pendulum. Gently nudge the pendulum to either side using your easily. It should proceed swinging on its own after you kickoff information technology.^[four]
- The pendulum should not rub against the clock chiffonier and should swing freely. If this is not the case, then the clock probably isn't completely vertical. Readjust and endeavour again.
- You should also listen to the ticking. If the clock does not tick evenly on both sides, y'all should readjust the straightness of the clock until the ticking sounds even.

1
Turn the minute hand counterclockwise. Plow the long manus of the clock to the left until you lot reach the right time.
- When done in this manner, the cuckoo call should ready itself automatically. In that location is no need to interruption and cheque the audio.
2
Alternatively, turn the minute hand clockwise and pause. If you lot plough the long hand to the right, yous must intermission at every 60 minutes ("12") and half hour ("6") marker before continuing to plough information technology.^[5]
- Await for the cuckoo phone call to stop playing before you plow the minute hand any further past these marks.
- If you have a musical clock, wait for the melody to terminate playing before you continue to turn the infinitesimal hand.
- When setting a cuckoo clock that has both cuckoo birds and quails, you will also demand to stop at the quarter past ("3") and quarter until ("9") marks. Wait for the call or music to finish before standing.
3
Never movement the hr hand. Do not turn the shorthand at all when setting the clock.^[6]
- Turning the 60 minutes hand instead of the minute mitt volition harm the clock.

Advertizing

ane
Discover the clock for 24 hours. Even if y'all purchased a new, pre-regulated cuckoo clock, you should observe it for a full 24 hours to determine if it is on time.^[7]
- Afterwards setting the original time, compare the time on the cuckoo clock to the time shown on another trusted clock, watch, or time-keeping device.
- Make sure to use a fourth dimension-keeping device that can be trusted. Stick with a watch or similar device that has e'er been reliable in the by.
2
Move the pendulum down to boring the clock. If the clock runs too fast, tedious it downwardly by carefully moving the pendulum bob down. This causes the pendulum to motility slower.
- The bob will usually look like a weighted disc or leaf.
- Monitor the clock for the rest of the twenty-four hours to make sure that this adjustment was correct.
Advertizement
3
Movement the pendulum up to speed up the clock. If the clock runs too slow, speed it upward by carefully pushing the pendulum bob up. This causes the pendulum to swing faster.
- The pendulum bob will usually be in the shape of a leaf or weighted disc.
- Continue checking the clock's accuracy to determine if this adjustment was correct.
iv
Air current as needed. The frequency with which you need to wind the clock will vary depending on the model, but you'll ordinarily need to wind it in one case every 24 hours or once every eight days.^[8]
- Each time y'all current of air the clock, do so in the same mode used to air current the clock initially. Pull the unweighted concatenation down to raise the weighted chain up equally high as it will go without resistance.
five
Conform the cuckoo shut-off switch as needed. The cuckoo racket of some clocks tin can exist switched of manually every bit desired. Make sure that the switch is adjusted to either play or mute the sound as desired.^[9]
- The switch can exist establish on either the bottom of the clock or to the left side.
- Unremarkably, you volition need to flip the switch off to turn off the cuckoo phone call and flip it down to plough the call back on over again. This can vary by model, though, and so you may demand to check with the manufacturer to verify the right fashion to use the transmission shut-off switch.
- Never adjust this switch while the cuckoo call or song is actively playing.
- Annotation that this feature is not available on every model. It can exist especially rare for vintage or antiquarian cuckoo clocks.

Add New Question

Question

Do cuckoo clocks need to be oiled?

This answer was written by one of our trained squad of researchers who validated information technology for accuracy and comprehensiveness.

wikiHow Staff Editor

Staff Answer

It's best to avoid oil-based lubricants within a cuckoo clock, since they can somewhen glue upwardly the gears. However, if the gears are sticking, a dry graphite lubricant can be helpful. You can use an oil-based cleanser to clean the woods casing of the clock and give information technology a overnice sheen.
Question

What'south the all-time identify to hang a cuckoo clock?

This answer was written past one of our trained squad of researchers who validated it for accuracy and comprehensiveness.

wikiHow Staff Editor

Staff Answer

Hang the clock in a prominent spot where it tin be a focal bespeak on your wall. For instance, you might display it in your family room or living room. Hang it 6.five-7 anxiety (nearly 2 meters) up on the wall for all-time viewing and to allow you to wind the clock easily. To avert damaging your clock, make sure non to hang it in an area where it will be exposed to loftier humidity or lots of direct sunlight throughout the day.
Question

How do you hang the weights on a cuckoo clock?

This answer was written by one of our trained team of researchers who validated it for accuracy and comprehensiveness.

wikiHow Staff Editor

Staff Answer

Mount the clock on the wall showtime and let the chains to hang down. Then, await at the bondage and locate the weight hooks. Observe the opposite terminate of each concatenation and pull it downward and then that the weight hook hangs approximately 3 inches (seven.six cm) from the bottom of the clock. Finally, carefully attach the weights to the hooks. If your cuckoo clock has iii weights, the heaviest ane goes farthest to the right (the other two should exist the same weight).

Run across more than answers

Inquire a Question

200 characters left

Include your email address to get a message when this question is answered.

Submit

Cheers for submitting a tip for review!

E'er use a gentle touch when setting and handling a cuckoo clock. The inner workings of the clock are delicate and precise, so applying besides much force can cause the clock to suspension.

Advert

Things You lot'll Demand

Cuckoo clock
Long #8 or #10 wood screw
Drill or screwdriver
Stud finder
Secondary clock, lookout, or like time-keeping device

Well-nigh This Article

Article Summary X

To set a cuckoo clock, you'll need to hang the clock on a wall, first it, then plough the minute hand to the correct time. Start with the clock hanging vertically on the wall. Then, wind the clock by gently pulling the chain without a weight on information technology towards the floor. Gently nudge the pendulum to i side to the clock starts ticking. Finally, plough the minute hand to the left until you reach the correct time. Never turn the hour mitt, since this can damage your clock. For more tips, including how to speed upward or wearisome down a cuckoo clock, read on!

Did this summary aid you?

Thank you to all authors for creating a page that has been read 169,404 times.